Henny-penny 341 User Manual download pdf

Model OFE/OFG/OEA/OGA-341, 342

5-1. TROUBLE SHOOTING GUIDE

Problem Cause Correction

POWER switch ON but fryer • Open circuit • Plug fryer in

completely inoperative

• Check breaker or fuse at supply

box

Shortening will not • Open high limit • Reset high limit per

heat but lights are on. circuit High Limit Temperature

Error message “E10” Control Section

• Drain valve open • Turn drain valve handle to

Error message “E15” closed position

Foaming or boiling • Water in shortening • At end of Cook Cycle, drain

over of shortening shortening and clean

• Improper or bad • Use recommended shortening

shortening

• Improper filtering • Refer to the procedure covering

filtering the shortening

• Improper rinsing after • Clean and rinse the frypot, then

cleaning the fryer dry thoroughly

Shortening will not • Drain valve clogged • Open valve, force cleaning

drain from frypot with crumbs brush through drain

Filter switch on, • Motor thermal • Reset thermal switch per section

motor does not run protector tripped on Filter Pump Motor

Protector – Manual Reset

More detailed troubleshooting information is available in the Technical Manual, available at

www.hennypenny.com, or 1-800-417-8405 or 1-937-456-8405.

903 5-1

SECTION 5. TROUBLESHOOTING

1 2 3

Model OFE/OFG/OEA/OGA-341, 342 5-1. TROUBLE SHOOTING GUIDE Problem Cause Correction POWER switch ON but fryer • Open circuit

Page 2

Model OFE/OFG/OEA/OGA-341, 342 5-2. ERROR CODES In the event of a control system failure, the digital display will show an "E

Model OFE/OFG/OEA/OGA-341, 342 5-2. ERROR CODES (Continued) DISPLAY CAUSE PANEL BOARD CORRECTION “E-20 A”

No comments

Henny-penny 341 User Manual