Henny Penny PFE-590 User Manual

OPERATOR’S MANUALHenny PennyPressure FryerModel PFE-590Model PFE-592

Model PFE- 590/592This section provides the installation and unpacking instructions forthe Henny Penny PFE-590.Installation of this unit should b

Model PFE- 590/5927. Remove the counterweights from the pallet, which arestrapped to the pallet, under the fryer.Do not drop. The counterweights

Model PFE- 590/592Optional Ramp Unloading2-3 1103

Model PFE- 590/592404 2-4

Model PFE- 590/592The proper location of the fryer is very important for operation,speed, and convenience. Choose a location which will providee

Model PFE- 590/5922-5. VENTILATION OF FRYER The fryer should be located with provision for venting intoadequate exhaust hood or ventilation syste

Model PFE- 590/5922-7. INTERNATIONAL Units being used outside the United States may not be shipped ELECTRICAL with the power cord attac

Model PFE- 590/5922-7. INTERNATIONAL ELECTRICALREQUIREMENTS(Continued)• The supply power cords shall be oil-resistant, sheathed flexibl

Model PFE- 590/592BOIL-OVER PREVENTION IN HENNY PENNY COOKERSFAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN SHORTENINGOVERFLOWING THE FRYPOT

Model PFE- 590/592

Model PFE- 590/5923-1. OPERATING COMPONENTSPOWER/PUMP Switch A three way switch with center OFF position; move the switch tothe position mark

Model PFE- 590/5923-1. OPERATING COMPONENTS (Continued)Safety Relief Valve RingDO NOT PULL THIS RING. SEVERE BURNS FROMTHE STEAM WIL

Model PFE- 590/5923-1. OPERATING COMPONENTS (Continued)High Temperature Limit This is a safety component that senses the temperature of thesho

Model PFE- 590/5923-2. LID OPERATION Continued)DO NOT LIFT HANDLE OR FORCE LID LATCHOPEN BEFORE PRESSURE GAUGE READS “0”PSI. ESCAPING STEAM AND

Model PFE- 590/5923-4. SWITCHES AND Refer to image at end of this section. INDICATORSEXIT COOL Button After cooking, or filtering the s

Model PFE- 590/5923-4. SWITCHES AND INDICATORS (Continued)HI Temperature Indicator The display reads “HI” if the shortening temperature is 40°

Model PFE- 590/5923-4. SWITCHES AND INDICATORS (Continued)TEMPERATURE BUTTON DIGITAL DISPLAY PRODUCT BUTTONSFigure 3-23-7

Model PFE- 590/5923-5. FILLING OR ADDING SHORTENINGThe shortening level must always be above the heatingelements when the fryer is heating an

Model PFE- 590/5923-6. BASIC OPERATION Follow the procedure below on the initial start-up of the fryer, andeach time the fryer is brought from

Model PFE- 590/5923-6. BASIC OPERATION 4. Allow fryer to heat until digital display shows “DROP”. (Continued) (Press the EXIT COOL button if t

FM05-032-GRevised 8-6-10LIMITED WARRANTY FOR HENNY PENNY EQUIPMENTSubject to the following conditions, Henny Penny Corporation makes the following lim

Model PFE- 590/5923-7. CARE OF THE SHORTENINGFOLLOW THE INSTRUCTIONS BELOW TO AVOIDSHORTENING OVERFLOWING THE FRYPOT,WHICH COULD RESULT I

Model PFE- 590/5923-8. FILTERING INSTRUCTIONS (continued)ONLY FILTER WHEN “COOL” IS DISPLAYED.FAILURE TO DO SO CAN RESULT IN SHOR

Model PFE- 590/5923-8. FILTERING 5. Scrape cracklings and crackling ring from frypot and discard. INSTRUCTIONS Do not let cracklings drain i

Model PFE- 590/5923-10. CLEANING THE FRYPOT After the initial installation of the fryer, as well as before everychange of shortening, the frypo

Model PFE- 590/5923-10. CLEANING THE FRYPOT (Continued)Do not use steel wool, other abrasive cleaners or clean-ers/sanitizers containing chlori

Model PFE- 590/5923-13. PREVENTIVE Cleaning Deadweight Assembly - Daily MAINTENANCEDO NOT ATTEMPT TO REMOVE DEADWEIGHTCAP WHILE FRY

Model PFE- 590/5923-13. PREVENTIVE Reversing Lid Gasket (Continued) MAINTENANCE Continued)Be sure the metal arm on the left side o

Model PFE- 590/5923-13. PREVENTIVE Cleaning Safety Relief Valve-Annually MAINTENANCE Continued)DO NOT ATTEMPT TO REMOVE SAFETY VAL

Model PFE- 590/5923-14. PROGRAMMING 1. Press and hold the FUNCTION button for two seconds.“REG PROGRAM” shows in the display, followed by“CODE

Model PFE- 590/5923-14. PROGRAMMING 8. After the load compensation, press and release the (Continued) FUNCTION button. “PROP” and “CO

HENNY PENNY8 HEAD ELECTRIC PRESSURE FRYERSPECIFICATIONSHeight 61" (155 cm)Width 24" (61 cm)Depth 41¾" ( 107 cm)Floor Space Approximatel

Model PFE- 590/5923-14. PROGRAMMING 13. After the filter value is set, press and release the FUNCTION (Continued) button. “EOC” and “E

Model PFE- 590/5923-15. SPECIAL PROGRAM MODE Reset Usage (Continued) 1. Press and hold the FUNCTION button for two seconds until“RE

Model PFE- 590/5923-15. SPECIAL PROGRAM MODE Tech I/O Mode (Continued) 1. Press and hold the FUNCTION button for two seconds until“

Model PFE- 590/5923-15. SPECIAL PROGRAM Heat Control MODE (Continued) 1. Press and hold the FUNCTION button for two seconds until“R

Model PFE- 590/592Power switch on but fryercompletely inoperativePressure not exhausting atend of Cook CycleOperating pressure too high4-1. TR

Model PFE- 590/5924-2. ERROR CODES In the event of a control system failure, the digital display willshow an “Error Message”. These messages

Model PFE- 590/592

Model PFE- 590/592G L O S S A R YHENNY PENNY PRESSURE FRYERSair valve a valve that allows air into the filter lines when the pump is on in the mi

Model PFE- 590/592counterweight assembly an assembly of weights and cables that enable the eight head fryer lid to lifteasilycracklings the crumb

Model PFE- 590/592filter drain pan a pan that rolls or slides under the fryer into which shortening is drainedfilter envelope a fiber envelope in

TABLE OF CONTENTSSection PageSection 1. INTRODUCTION ...

Model PFE- 590/592lid assembly an assembly comprised of lid, lid handle, lid latch, and lid gasket (Note: on fourhead fryers. the lid assembly

Model PFE- 590/592sift breading the process of removing clumps from breadingsolenoid valve a valve used to generate or release pressure for the c

*FM05-032-G* Henny Penny Corp., Eaton, Ohio 45320, Revised 8-6-10Henny Penny CorporationP.O.Box 60Eaton,OH 453201-937-456-84001-937-456-8402 FaxToll

Model PFE- 590/592The Henny Penny pressure fryer is a basic unit of food pro-cessing equipment which is used only in institutional and commercial

Model PFE- 590/592The Henny Penny pressure fryer has may safety featuresincorporated. However, the only way to ensure a safe operationis to fully

Model PFE- 590/5921-5. SAFETY (Continued)Equipotential Ground SymbolWaste Electrical and Electronic Equipment (WEEE) SymbolShock Hazard S