Henny-penny 323 User Manual download pdf (Page 8)

Model OFE/OFG-321,322,323,324

2-11. TESTING THE FRYER Each Henny Penny pressure fryer was completely checked

and tested prior to shipment. However, it is good practice to

check the unit for proper operation.

2-12. JOINING INSTRUCTIONS The following instructions are for joining two units together.

The instructions have part numbers in them. Please refer to

figure 2-1 on the following page to visually match the

numbers in the instructions below to the illustration.

1. Remove all hardware from the sides of the two open

fryers.

2. Remove the right control panel assembly from the left

unit and the left control panel assembly from the right

unit.

3. Move the two units side by side with minimal gap.

4. Remove the right front caster from the left unit and the

left rear caster from the right unit. Fasten both casters to

the rear of the unit with wire ties (EF02-041).

5. Position the two open fryers by inserting bolts

(SC01-227) thru the holes in top cover and the pot sides.

Use washer (WA01-017) on both sides of the bolt when

installing. DO NOT TIGHTEN!

6. Position front spacer (60554) between the front of the

two open fryers. Place bolt (SC01-231), backed by

washers (55350 & WA01-016), thru three holes in the

frame capturing the spacer between the frames. Place

washers

(55350 & WA01-016) on bolt before installing nuts

(NS02-010). DO NOT TIGHTEN!

7. Repeat with rear spacer (60555).

8. Tighten all fasteners securely.

9. Place cover (60593) over gap between open fryers.

10. Drill out dimples on rear shroud to 0.250 diameter holes.

11. Apply silicon around edge of unfinished side of rear

cover (60599). Install rear cover (60599) with #8 nuts

(NS02-007).

211 2-8

1 2 3 4 5 6 7 8 9 10 11

No comments

Henny-penny 323 User Manual Page 8