Henny-penny EEE-143 User Manual download pdf (Page 61)

Model EEE-141,142, 143, 144

7-2. ERROR CODES

DISPLAY CAUSE CORRECTION

“E-21” Slow heat recovery Have a certified service technician check the fryer for correct

voltage to the unit; have the contactors and heating element

checked; have unit checked for loose or burnt wires

“E-22” “NO HEAT” Elements not Check power cord and heat circuit

“CHECK PWR heating

CORD AND

BREAKER”

“E-31” Elements are up Lower elements completely back into the vat

“E-41”, “E-46” Programming Turn switch to OFF, then back to ON; if display shows any

failure of these error codes, have the controls re-initialized; if error code

persists, have the control board replaced

“E-47” Analog converter Turn switch to OFF, then back to ON; if “E-47” persists,

chip or 12 volt have the I/O board, or the PC board replaced; if speaker

supply failure tones are quiet, probably I/O board failure; have the I/O board

replaced

“E-48” Input system Turn switch to OFF, then back to ON; have controlPC board

error replaced if “E-48” persists

“E-54C” Temperature input Turn switch to OFF, then back to ON; have control PC board

error replaced if “E-54C” persists

“E-60” AIF PC board not Press power button to vat off and back on again if “E-60”

communicating with persists, have the connector between the PC boards checked;

control PC board replace AIF PC board or control PC board if necessary

7-4 909

1 2 ... 56 57 58 59 60 61 62 63

No comments

Henny-penny EEE-143 User Manual Page 61