Henny-penny OFE-321 User Manual download pdf (Page 16)

Model OFE-321,322

2-9. HEATING ELEMENTS

Heating elements are available for 208, 480 and 230 volts. Check

data plate to determine correct voltage.

Checkout:

If the shortenings temperature recovery is very slow or at a slower

rate than required, this may indicate defective heating element(s).

An ohmmeter will quickly indicate if the elements are shorted or

open.

1. Remove electrical power supplied to the frypot to be worked on.

To avoid electrical shock or property damage, move the

POWER switch to OFF and disconnect main circuit

breaker, or unplug cord at wall receptacle, to the frypot

to be worked on. Be aware the other controls will have

power.

2. Remove control panel.

3. Perform an ohm check on one element at a time, with wires

disconnected from element. If the resistance is not within

tolerance, replace the element.

Voltage Wattage Resistance Ohms (cold)

208 7333 5.6

240 7333 6.9

480 7333 27.5

Replacement:

Refer to figure 2-2.

1. Drain the shortening from the frypot.

2. Remove the high limit bulb holder from the heating element

inside the frypot.

2-5 405

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

No comments

Henny-penny OFE-321 User Manual Page 16